Service 03 of 07

Hydraulic & Pneumatic Test Systems

Test benches and rigs that load a component under real working pressure and flow, capture what it actually does, and report it. Covers hydraulic pumps, motors, valves, hoses and accessories, and pneumatic pressure, filling and leak-test applications.

Measured pressure and flow take the guesswork out of troubleshooting. Flow at pressure reveals volumetric efficiency, the recognised indicator of internal leakage and wear, and recorded parameters let condition be compared from one test to the next.

Benches are built around the pumps and vehicles you actually service, with stable oil temperature, regulated pressure and servo- or engine-driven speed engineered in so that results are repeatable.

Discuss a Project How We Deliver

What This Covers

Hydraulic

Pump and motor performance testing at rated pressure and flow
Directional control valve, relief valve and NRV testing
Hose and accessory proof and leak testing

Pneumatic

Compressed-air cylinder and receiver filling
Pressure and leak testing of hoses, valves and fittings
Portable and workshop-based filling systems

Measurement

Pressure, flow, temperature, torque and speed logging
Automatic performance report generation
Self-diagnosis of the bench's own valves and sensors

What You Receive

Instrumented test bench or rig, factory tested
LabVIEW test interface with performance reports
Health-monitoring sensors and fault indication
Calibration and verification support through service life

Typical engagement models

Test-System DevelopmentDesign & Build (Turnkey)

Six ways to place work with us are described on the homepage. Acceptance is always against measured performance, demonstrated before dispatch and repeated at site during commissioning.